33
Chapter 6: Setting up the Wireless-G Router for Broadband WAN Service Only
Using the Setup Wizard
Wireless-G Router for 3G/UMTS Broadband
12. Select the Internet connection type you use: Cable (DHCP), DSL (PPPoE), or Static IP. Proceed to the
appropriate section for your Internet connection type.
Cable (DHCP)
Click the Next button.
DSL (PPPoE)
User Name - Enter the User Name provided by your ISP.
Password - Enter the Password provided by your ISP.
Confirm - To confirm the Password, enter it again in this field.
Click the Next button to continue.
Figure 6-10: Configure Cable or DHCP Settings Screen
Figure 6-11: Configure DSL (PPPoE) Settings Screen
NOTE: If the Internet connection type you use is not listed here, keep the default, Cable (DHCP)
for now, and click the Next button. After you have completed the Setup Wizard, go to “Chapter 8:
Configuring the Wireless-G Router for 3G/UMTS Broadband.” You will use the Router’s web-
based utility to configure the Internet connection type settings.
To Next Page
Loading...
