Linksys WRT54G3G

37
Chapter 6: Setting up the Wireless-G Router for Broadband WAN Service Only
Using the Setup Wizard
Wireless-G Router for 3G/UMTS Broadband
WPA-Personal
To use WPA-Personal security, enter a Passphrase that is 8-32 characters in length.
Passphrase - Enter a passphrase, also called a pre-shared key, of 8-63 characters in the Passphrase field.
The longer and more complex your Passphrase is, the more secure your network will be.
Click the Next button to continue or the Back button to return to the previous screen.
WEP (64-Bit)
Enter a passphrase or WEP key.
Passphrase - Enter a passphrase, and then click the Generate button, so a WEP key is automatically
generated. The passphrase is case-sensitive and should not be longer than 16 alphanumeric characters. It
must match the passphrase of your other wireless network devices and is compatible with Linksys wireless
products only. (For any non-Linksys wireless products, enter the WEP key manually on those products.)
Key 1 - The WEP key you enter must match the WEP key of your wireless network. For 64-bit encryption,
enter exactly 10 hexadecimal characters. Valid hexadecimal characters are “0” to “9” and “A” to “F”.
Click the Next button.
WEP (128-Bit)
Enter a passphrase or WEP key.
Passphrase - Enter a passphrase, and then click the Generate button, so a WEP key is automatically
generated. The passphrase is case-sensitive and should not be longer than 16 alphanumeric characters. It
must match the passphrase of your other wireless network devices and is compatible with Linksys wireless
products only. (For any non-Linksys wireless products, enter the WEP key manually on those products.)
Key 1- The WEP key you enter must match the WEP key of your wireless network. For 128-bit encryption,
enter exactly 26 hexadecimal characters. Valid hexadecimal characters are “0” to “9” and “A” to “F”.
Click the Next button.
Figure 6-18: Configure Wireless Security Settings -
WPA-Personal Screen
Figure 6-19: Configure Wireless Security Settings - WEP
(128-Bit) Screen