You will need two suitable screws (See Figure 5-7) to mount the Router. Make sure the
screw size can fit into the criss-cross wall-mount slots.
1. 1. On the Wireless Router’s back panel are two criss-cross wall-mount slots.
2. 2. Determine where you want to mount the Wireless Router, and install two screws that are
2-9/16 in (64.5mm) apart.
3. 3. Line up the Wireless Router so that the wall-mount slots line up with the two screws.
Figure 5-7: Mounting Dimensions
4. 4. Place the wall-mount slots over the screws and slide the Wireless Router down until the
screws fit snugly into the wall-mount slots.
Now that the hardware installation is complete, proceed to “Chapter 6: Setting up and
To Next Page
Loading...
