Linksys WUSB100 User Manual

Chapter 3
Advanced Configuration
6
RangePlus Wireless USB Network Adapter
The 5. Checking Connection screen appears.
Checking Connection
The 6. Connected to Your Network screen appears. If you
want the Wireless Manager to save your network’s
settings, click Remember this network. Click Finish
to exit the Wireless Manager.
NOTE: Saving a hidden network’s settings will
make it easier to reconnect to the network.
Connected to Your Network
Congratulations! The Adapter is connected to
the network.
How to Connect Using Wi-Fi Protected Setup
On the Connect to a Wireless Network screen, the Wi-Fi
Protected Setup icon ( ) indicates a network that supports
Wi-Fi Protected Setup. Follow these instructions to connect
to a wireless network using Wi-Fi Protected Setup.
NOTE: Before you begin, make sure the router
and the computer with the Adapter are in the
same room .
Select your network in the 1. Connect to a Wireless
Network screen, and then click Connect.
Select the Wireless Network
The 2. Quickly Connect Using Push Button screen appears.
Quick Connect Using Push Button
Press the3. router’s Wi-Fi Protected Setup button .
If your router does not have this button, click Skip and
go to Enter the Adapter’s PIN Number, page 7.
Within two minutes, click 4. Connect on the Quickly
Connect Using Push Button screen.

Linksys WUSB100 Specifications

General

Maximum data transfer rate	0 Mbit/s
Connectivity technology	Wireless
Component for	PC/Laptop
Plug and Play	Yes
Security features	Wi-Fi Protected Access (WPA2)