Linn Klimax - Parameter Settings Klimax 345; External high pass frequency; Internal high pass frequency; Internal low pass frequency

20
KLIMAX
Loudspeaker System
Owner’s Manual
English Klimax 345
DDescription and available settings for parameters
Default settings are shown in grey.
Parameter Symbol 0 1 2 3 4 5 6 7 8 9
10 50 75 100 115 135 160 190 235
18 22 25 30 34 40
55 85 130
-15 -10 -5 0 +5 +10 +15
0 +1 +2 +3 +4
External high pass
frequency.*
Increasing the setting
reduces the bass content
sent to the external
loudspeakers. (Hz)
Internal high pass frequency.
Increasing the setting raises
the lowest frequency
produced by the unit. (Hz)
Internal low pass frequency.
Increasing the setting raises
the highest frequency
produced by the unit.
Reducing the setting lowers
the highest frequency
produced by the unit. (Hz)
Coarse gain. Every one step
increase in the setting raises
the gain (volume) of the
loudspeaker by 5 decibels.
Every one step decrease in
the setting lowers the gain
(volume) of the loudspeaker
by 5 decibels. (dB)
Fine gain. Every one step
increase in the setting raises
the gain (volume) of the
loudspeaker by 1 decibel.
(dB)
No filtering
* Only for use when the Klimax 345 loudspeaker is connected to a power amplifier
(see
Connecting section in this chapter).
0 +3 +6
5 10 20
Bass equalisation.
Every one step increase in
the setting applies an
additional 3dBs at 30 Hz and
below. (dB@30 Hz)
Time out. Length of time
before unit will go into
standby after audio input
ceases. (mins)
Parameter Symbol 0 1 2 3 4 5 6 7 8 9
Always on