12
// DISABLING THE HIGH VOLTAGE
Disabling the high voltage
The vehicle’s ignition must be turned o prior to disabling the
high voltage
(See page 11).
1. Check the charging receptacle located in the passenger
steps to make sure that the vehicle is NOT connected. If
the vehicle’s charging receptacle is connected, remove the
connector.
2. Open the accessory compartment located behind the
driver’s (left) front wheel. Locate the master disconnect
switch and turn it o. Turning o this switch deactivates the
low and high voltage. (See page 10)
3. Double cut the battery cables on both low-voltage batteries
located in the accessories compartment. (See page 10)
DANGER
Do NOT cut any orange-coloured high-voltage cable wires.
Figure 10 ― Master disconnect switch location
Figure 11 ― Two low-voltage batteries
To Next Page
Loading...