11
WWW.LIONPROTECTS.COM
PROGRAMMING THE SMOKE GENERATOR
1. Press the MENU button one time to bring up the programming display screen.
Use the UP, DOWN and ENTER buttons to navigate this screen.
2. Pressing ENTER when the arrow is on the “Initial Delay” setting (as seen
in Figure 3) will allow you to set the amount of time before the Smoke Generator
begins creating smoke. Use the UP and DOWN arrows to select the time in
hours (H) and minutes (M) and press ENTER to conrm it.
3. There are two modes available, AUTO and TIMER. Figure 3 displays the
AUTO option which is “Room Size”.
FIGURE 3: PROGRAMMING DISPLAY (AUTO)
FIGURE 4: PROGRAMMING DISPLAY (TIMER)
4. Use the UP and DOWN buttons to navigate the cursor down to “Room Size” and
press ENTER to change the value. Room size options include small, medium and
large and the Smoke Generator will, after waiting for the specied “Initial Delay”
time, create smoke until reaching its automatic shut-off level. Press ENTER
again to conrm the changed setting.
5. To use the TIMER settings, use the UP and DOWN buttons to move the arrow to
“Mode” and press ENTER, then UP or DOWN to change the value. When TIMER
is selected, the display will appear as seen in Figure 4.
CONTINUES >
To Next Page
Loading...
Need help?
General
