LION SG4000 User Manual

SMOKE GENERATOR
16
WWW.LIONPROTECTS.COM
5. ERROR CODES
The Smoke Generator has the ability to display a variety of error codes which can
provide you with information if something is impeding the optimal operation of the
device. If one or more errors are detected, no smoke will be produced. The error
codes can be cleared from the display by correcting the error. Errors are shown
on the display below the standard display as seen in Figure 9. If several errors
are detected at the same time, these will be shown sequentially at half-second
intervals. The error codes are dened below.
Code Definition Heating Comments
E1 When the generator is
started, the settings are
read by the device.
Error 1 indicates that
the device is unable to
read the setting values.
No The smoke generator fails to
work because the settings are
invalid or cannot be read.
Correct operation cannot be
guaranteed. This error message
cannot be removed. Factory
calibration is needed.
E3 Heating element 1 has
been switched on but
there is no feedback.
No There is a problem with
heating element 1. This problem
could be the drive circuitry,
feedback circuitry, or actual
heating element. Factory
repair is needed.
E4 Heating element 2 has
been switched on but
there is no feedback.
No There is a problem with
heating element 2. This problem
could be the drive circuitry,
feedback circuitry, or actual
heating element. Factory
repair is needed.
E5 The uid level is too low. Yes More uid needs to be added
and the generator should then
be restarted.

LION SG4000 Specifications

General

Brand	LION
Model	SG4000
Category	Fog Machine
Language	English