17
WWW.LIONPROTECTS.COM
Code Definition Heating Comments
E6 The temperature of the
heating element casing
has risen above the
maximum value.
No Wait until the temperature
falls. This can take several
minutes. If this error occurs
regularly, calibration or repair
will be needed.
E7 The temperature of the
heating element itself
has risen above the
maximum value set.
No Wait until the temperature
falls. This can take several
minutes. If this error occurs
regularly, calibration or repair
will be needed.
E8 The temperature of
the heating element
has fallen below the
minimum value set.
Yes The temperature should come up
to the required level very quickly.
If it does not, something may need
to be corrected with the heating
element. Factory repair is needed.
E9 Heating element 1 has
been switched off but it
is still functional.
No There is an error in the drive of
heating element 1. Switch off
the equipment IMMEDIATELY
to prevent overheating. Factory
repairs needed.
E10 Heating element 2 has
been switched off but it
is still functional.
No There is an error in the drive of
heating element 2. Switch off
the equipment IMMEDIATELY
to prevent overheating. Factory
repairs needed.
FIGURE 9: STANDARD DISPLAY WITH ERROR MESSAGE
To Next Page
Loading...
Need help?
General
