Lionelo Braam - Seat Liner & Covering; Seat Liner Usage & Removal; Removing Seat Covering; Car Installation with Safety Belts (Part 1)

‑ 13 ‑ EN
• Children from group II, III, (15 - 36 kg) can be in a forward-facing posion in posion
1 only.
SEAT LINER
The seat liner is intended for babies, raises their comfort and serves as addional support
(see: g. 19). If the child needs more space in the child safety seat, remove the seat liner.
HOW TO REMOVE COVERING
• Remove 5-point belts of the child safety seat. (See: g. 8 and 9)
• Li the headrest as high as possible.
• Unfasten Velcros and remove the covering from the child safety seat.
To put the cover back on, follow the steps above in a reversed order.
HOW TO INSTALL IN THE CAR
A. ASSEMBLY WITH SAFETY BELTS
1. Installaon in a rear-facing posion, the child secured with safety belts of the child
safety seat (group 0+, 0 - 13 kg).
• Place the child safety seat on the car seat.
• Turn the child safety seat to the rear-facing posion; to do so, press the base rotaon
buon (M) (see: g. 13).
• Press the support leg adjustment buon (Y), then extend the leg and adjust its length
so that it contacts the vehicle oor (the indicator will turn green when the support leg
is suciently extended).
• Pull the car seat belt.
•
Carry the shoulder part of the belt (D) through the shoulder belt guide (A) marked in blue.
• Carry the hip part of the belt through the hip belt guide (P) marked in blue.
•
Press the child safety seat against the car seat as much as you can. Pull the hip belt
towards the buckle in order to ghten it as much as possible. Next pull the shoulder
belt to ghten other parts of the belt. Make sure the belts are not twisted and properly
hold the child safety seat.
•
Put the child in the child safety seat and secure it with product’s safety belts. (See: g. 20)
Informaon:
• For children from group 0+, the child safety seat must be xed in a rear-facing posion
only, and inclinaon angle must be as high as possible (posion no. 5). To make sure
the child safety seat is properly installed, try to move it before use.
• Make sure the car seat belt is not twisted!
• Make sure the belts have been properly fastened. Aer fastening, you should hear a
disncve „click”. (See: g. 20)