EasyManua.ls Logo

Lipper Curt - Resources Required

Default Icon
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Rev: 08.30.21 Page 3 CCD-0004385
Do NOT connect red, positive (+) battery cables rst. Connecting red, positive (+) cables to the
battery rst can cause an electrical shock resulting in severe personal injury, including severe
burns. Connect black, negative (-) battery cables to the negative (-) battery post rst, followed by
connecting the red, positive (+) battery cables to the positive (+) battery post.
Do NOT mix and match dierent capacity batteries in series. Combining dierent capacity batteries
in series will cause the lower capacity battery to charge up faster and become overcharged, causing
irreplaceable gases to vent which may cause an explosion resulting in personal injury and product
and/or property damage. For series battery connection, only connect batteries that are as close to
identical as possible.
Car battery fluid is acidic. Wear proper clothing to protect your face, hands and body.
Do not lift or handle the battery by its terminals or damage to the terminals may occur.
Work in a well-ventilated area.
Keep batteries away from ignition sources.
Check for proper battery polarity.
Use of metallic tools or conductors can cause short circuits and sparks. Use caution when using
metallic tools or conductors around battery terminals.
Keep batteries out of reach of children.
Always wear eye protection when performing service, maintenance or installation procedures.
Other safety equipment to consider would be hearing protection, gloves and possibly a full face
shield, depending on the nature of the task.
The “CAUTION” symbol above is a sign that a safety risk is involved and may cause personal injury
and/or product or property damage if not safely adhered to and within the parameters set forth
in this manual.
Resources Required
Rivet gun
Cordless or electric drill or screw gun
Appropriate drive bits
Appropriate drill bits
Ignition-protected circuit breakers
#10 Self-drilling screws (1/2" max length)
6 AWG wire (if necessary)
Appropriate torque wrench