What to do if my Lippert Components Power Gear SlimRack Slide-out shows low voltage?
If your Lippert Components Motorhome shows a low voltage error, it means the incoming voltage to the control is below 12.0 VDC. You can start the vehicle, generator, or ensure the coach is plugged into shore power. Also, check the 2-pin power connector at the control box at BATT + and GND.
Why is the park brake not set on my Lippert Components Motorhomes?
If the park brake is not set on your Lippert Components Motorhomes, it may be because the park brake is not engaged, or there is a loss of ground signal at the park brake receptacle at the control box. Set the parking brake and check for continuity to ground on the wire plugged into the park brake receptacle at the control box.
Specifies voltage, wiring, and control requirements for system installation.
Details installation of floor rollers and attachment of end brackets.
Covers mounting the controller, rocker switch, and routing harnesses.
Procedure to set the stop point for the room when retracting.
Procedure to set the stop point for the room when extending.
Essential checks before operating the slide-out room.
Step-by-step instructions for extending the slide-out room.
Step-by-step instructions for retracting the slide-out room.
Interpreting LED flashes on the control box and rocker switch for faults.
Detailed chart correlating fault codes with causes and recommended actions.
Using a square drive tube to manually retract the room.
Using a ratchet and socket to manually retract the room.
Diagrams and pinouts for control box 151000276 and its harnesses.
Diagrams and pinouts for control box 151000236 and its harnesses.
General| Category | Motorhomes |
|---|---|
| Brand | Lippert Components |
| Product | Power Gear SlimRack |
| Product Line | Power Gear |
| Drive Type | Electric |
| Voltage | 12V DC |
| Manufacturer | Lippert Components, Inc. |
| Type | Slide-out |
| Application | RV Slide-out Rooms |
| Control | Wall-mounted switch |
| Construction | Steel |
| Features | Slim design |
To Next Page
