What to do if Lippert Schwintek error codes are present?
If error codes are present, try energizing the extend/retract switch to reset the board. You can also refer to the Error Code Chart for further assistance.
Why Lippert Schwintek status LEDs do not light when the switch is activated?
If the status LEDs do not light while the switch is activated, check for 12VDC in to controller, check for 12VDC at the switch connection on both extend and retract, and check the battery for 12VDC.
General| Operation | Electric |
|---|---|
| Installation | Professional installation recommended |
| Capacity | Varies by model |
| Control | Keypad or Remote |
| Compatibility | RV Slide-Outs |
| Type | Slide-Out System |
List of tools required for installation, including drill, bits, and tape measure.
Instructions for mounting racks onto a solid surface, ensuring parallel alignment and proper spacing.
Steps to bolt plywood pieces and measure gap for mattress support, ensuring clearance.
Procedure to set the top and bottom limits using the configuration button and wall switch.
List of error codes, their names, and descriptions for diagnosing motor-specific faults.
To Next Page
