Lippert Schwintek - Resources and Installation; Tools Needed for Installation; Mounting the Racks

Rev: 02.03.2017
Page 3
Schwintek Bed Tilt Install Manual
Resources Required
Tools Needed
• Cordless or Electric Drill or Screw Gun
• Appropriate Drill/Drive Bits
• Tape Measure
Installation
Racks
1. Mount racks onto a solid surface (Fig. 1) under the bed with #10 screws (a minimum requirement),
filling every hole in the rack (Fig. 2).
NOTE: Make sure racks are parallel to each other.
2. The back of the rack should be
½
" away from the outside wall of the bed slide to ensure there is
enough space for the bed tilt to fully operate (Fig. 3).
Fig. 1
Fig. 2 Fig. 3
Solid Surface
Mount
½
"
away from
outside wall