Lippert Solera Classic - Page 6

Rev: 08.09.21 Page 6 CCD-0001361-AU
6. Walk the awning in toward the unit. Hook the pull rod into the pull strap before the strap gets too
high. Using the pull rod, walk the awning to the fully-closed position. Remove the hook from the pull
strap and store in a secure location.
7. Secure travel locks accordingly as they appear on the unit.
A. Original Travel Locks - Lock the arms for travel mode by compressing the outer arm (Fig. 9E)
and support arm (Fig. 9A) together until the outer arm clicks into the travel locks (Fig. 9B) on the
support arm.
B. Current Travel Locks - Lock the arms for travel mode by compressing the outer arm (Fig. 11E)
and support arm (Fig. 11A) together. Swing the travel lock body (Fig.10B) down onto the travel
lock base (Fig.10A). The travel lock body will press onto and latch close on the travel lock base.
The travel lock body's arm (Fig. 10C) will wrap behind the arms for secure travel mode.
Fig. 9
A
E
C
B
A
Fig. 10
C
Fig. 11
A
B
E
C
8. Tighten the black locking knob (Fig 9C).
NOTE: Other than the difference of travel locks, the awning assemblies, Figures 9 and 11, are the same.
Callouts A, C, and E in Figure 9 are the same as call outs A, C, and E in Figure 11.