Rev: 08.09.21 Page 5 CCD-0001361-AU
Extending Optional Car Port
1. After steps 1-8 in the Extending the Awning section have been completed, remove the outer arm
(Fig. 6A) from the side of the unit by releasing the lever (Fig. 6B) on lower mounting bracket (Fig. 6C).
2. Walk the awning out until the outer arm is straight up and down and let it set on the ground.
3. Make sure to secure the foot of the outer arm (Fig.6D) to the ground with the provided stakes.
Retracting the Awning
1. If the awning is in car port mode, remove the stakes from the foot of the outer arm (Fig. 6D). Walk the
outer arm back to the unit and secure it into the lower mounting bracket on the sidewall by pushing
the lever (Fig. 6B) on the lower mounting bracket (Fig. 6C) and inserting the outer arm pin (Fig. 6E) into
the lower mounting bracket of the unit. Repeat procedure on other end.
2. Unwrap the awning pull strap and return it to the center of the awning roll tube.
3. Lower the outer arms by releasing the outer arm assembly handle and allow the outer arm upper
channel (Fig. 5A) to slide down the outer arm lower channel (Fig. 5B) until it rests on the acorn nut.
Repeat the procedure for the other end.
Fig. 6
B
A
C
D
E
4. Loosen the black locking knob (Fig. 3C) and unlock the support arm by releasing the spring clip
(Fig. 7A) at the top of the outer arm head assembly. Allow the support arm to slide all the way down
toward the bottom of the outer arm. Repeat this for both ends.
5. Take a firm hold on the awning strap and release the tension on the springs by flipping the cam lock
(Fig. 8A) up to the roll in position.
Fig. 7 Fig. 8
A
A
To Next Page
Loading...
