Lippert Thin Shade 806621 - Installing the New Door Window Assembly; Installing the Thin Shade Component

5
lci1.com 574-537-8900 Rev. 06.04.21CCD-0002703
Entry Door Window
Replacement with
Thin Shade Kit
Installation and Owner’s Manual
(For Aftermarket Applications)
Install New Window
1. Place the new outer frame with glass against the exterior
of the door (Fig.5).
interior
window
frame
with catch
feature
exterior
window
frame with
protrusions;
glass
installed
Fig.5
Install Thin Shade
1. Unlatch the small levers at the top of the window frame
in a left-to-right direction (Fig.6).
levers
levers
Fig.6
2. Unlatch the levers at the bottom of the frame in a
right-to-left direction (Fig.6).
NOTE: Make sure the frame’s seal is positioned properly
against the door.
NOTE: The next step will require another person to assist
while preparing to install the interior frame.
2. While one person holds the exterior frame and glass
against the door, the other person snaps the interior frame
into the exterior frame. Make sure all 16 locking points click
into place.
3. Hold a wood block on one side of the frame and tap
the other side with a rubber mallet. The gap between the
frame and door will close when the seal is completely
compressed and the exterior frame touches the door.
4. Continue tapping the frame around its perimeter until all
16 points are fully locked.