Lippert Tire Linc - Configure All Thresholds

9
lippert.com 432-LIPPERT (432-547-7378) Rev: 09.29.21
Tire Linc
®
AU
Tyre Pressure & Temperature
Monitoring System 2.0
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0004069
4. Tap the FINISHED button (Fig.18A) to exit TYRE
PRESSURE Sensor Conguration mode.
Pressing FINISHED exits configuration mode and
redisplays the TYRE PRESSURE screen� Do NOT tap
the Learn Sensors button again� Doing so resets Tire Linc
into configuration mode, which requires uninstalling the
stem sensors�
NOTE: To exit learn mode, tap the back arrow and the
sensors will not be forgotten�
A
NOTE: When learning has been completed, the low and
high pressure limits of the tyres are estimated at +/- 20%
of the last received sensor data� Make sure sensors are
not removed during the learning process or the pressure
limit values will be incorrectly estimated� Pressure and
temperature limits can be set through the app after
learning has been completed�
NOTE: If installing the optional lock nut as a theft deterrent,
loosen stem sensor slightly and hand tighten lock nut
against the sensor� Using wrench provided in kit, hold
lock nut in position and hand tighten stem sensor against
lock nut�
A
B
Fig.17
Fig.18