Lippert True Course User Manual

3
lippert.com 432-LIPPERT (432-547-7378) Rev: 09.26.22
True Course
™
Electronic
Sway Control System
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0004358
Installation
1. Hold the control module against the roadside trailer
frame and mark the locations for four pilot holes (Fig.1).
NOTE: Before positioning the module for marks, make
sure there is adequate length on the attached front 7-way
cord to connect to the tow vehicle.
NOTE: Place the module so it is level to the top of the
frame where it is to be installed.
module level with
top of frame
1/8” pilot hole
1/8” pilot hole
7-way connector
from trailer
7-way cord to
tow vehicle
1/8” pilot hole
1/8” pilot hole
Fig.1
2. Using a 1/8” bit, drill pilot holes for the four ¼” self-drilling
screws (Fig.1).
3. Install screws to secure the module to the frame (Fig.1).
4. Connect the attached 7-way cord to the tow vehicle.
5. Attach the trailer’s 7-way connector to the back of the
control module.

Lippert True Course Specifications

General

Brand	Lippert
Model	True Course
Category	Controller
Language	English