To Next PageTo Next Page
Need help?Do you have a question about the Liquid Controls Avery-Hardoll BM250 and is the answer not in the manual?
General| Model | BM250 |
|---|---|
| Manufacturer | Liquid Controls / Avery-Hardoll |
| Category | Measuring Instruments |
| Repeatability | 0.02% |
| Size | 2 inch |
| Operating Pressure | Up to 150 psi (10.3 bar) |
| Temperature Range | -40°F to 160°F |
| Materials | Aluminum, Stainless Steel |
| Output Options | Pulse Output |
| Flow Rate | 5 to 250 lpm (1.3 to 66 USGPM) |
Details the construction and material of the bulkmeter manifold.
Describes the body casing, end covers, and internal machining of the bulkmeter.
Explains the rotor assembly, including vanes, rods, and their operation within the meter.
Illustrates the gear arrangement of the calibrating mechanism for meter adjustment.
Lists the materials used for various components of the bulkmeter.
Details maximum working pressure, hydrostatic test pressure, and recommended pressure drop.
Outlines the necessary procedures to perform before installing the meter.
Provides guidance and notes for the correct installation of the bulkmeter.
Details recommended minimum maintenance frequencies and daily checks.
General information regarding servicing procedures and necessary facilities.
Emphasizes the need for qualified personnel and adherence to safety procedures.
Steps for safely removing the bulkmeter from the pipeline system.
Step-by-step guide for dismantling the bulkmeter's body assembly.
Instructions for dismantling the calibrating mechanism.
Procedures for testing the bulkmeter after overhaul.
Introduction to fault finding and common issues with the bulkmeter.
