Introduction
The Digidown device downloads data from digital tachograph
vehicle units (VUs) from all current tachograph manufacturers.
Data downloaded from the Tachograph is stored in a Secure Digital
memory card, normally known as an SD card.
Three types of download are available:
ALL VU Downloads all contents from the VU
LATEST VU Programmable
1
. Options include the last 1 or 3
months of data plus a selection from events &
faults, detailed speed and technical information.
CARD Downloads a Driver Card inserted into the VU
If required, ‘Latest VU’ can also be programmed to include
download of a Driver card inserted in the VU.
Pressing the relevant button starts the Download. Download
status is indicated by the 3 LEDs positioned by the buttons.
Initial Set Up
In order to operate successfully, the Digidown requires an SD card
to be inserted into the slot in the end of the device. A suitable
ready-formatted SD card is supplied with the unit. When a
suitable memory card has been inserted into a Digidown and the
Digidown is connected to a VU it checks the card format and then
indicates that it is ready for use.
Insertion and removal of the SD card
When in use a suitable SD card must be inserted into the slot in
the bottom of the Digidown. To insert the card, push it into the
slot in the end of the Digidown until it latches in place. To remove
the SD card from the Digidown (for instance in order to read it
using a different memory card reader) the protruding end of the
memory card should be pushed back into the Digidown. This will
release the SD card and it will spring out for easy removal. DO
NOT try to remove the latched memory card by pulling on the end
of the card.
1
Please contact your dealer to discuss the options available.
To Next Page
Loading...
