6
BLADE
1. The blade must be lubricated before and after each use. This will maintain it in
good condition and will extend its service life.
2 Non-stop usage for hours may cause overheating of blades, reducing the cutting
performance and shortening their life. Should the blades overheat, switch the unit
off for a few minutes to let it cool down and lubricate the blades.
3. Hair must be clean and dry before cutting. Foreign matter hidden in the hair may
damage the blade edge.
4. Hair may gather in the inside of the blade housing during use. Too much stored
hair will reduce the oscillating ability of the blades and cause malfunctioning.
Always clean up hair in the blade housing before and after each use.
5. Avoid impact of the blade with hard objects as this may cause damage to the
blade teeth.
BATTERY
1. Do not overcharge. It takes 2.5 hours to charge your clipper. Charging over 36
hours may shorten the life of the battery.
2. The life of the battery will be shortened if the clipper remains uncharged for long
periods. Charge every 3 months of non-use to activate the battery.
3. It is normal for the adapter and the internal parts to become warm when charging.
OTHERS
1. Use or store the clipper only at room temperature. Avoid direct sunlight, moisture
or heated surfaces. Operating range 0 - 40 °C.
2. Do not attempt to unscrew any part of the clipper.
OPERATING INSTRUCTIONS
CHARGING
1. Switch off clipper.
2. Connect the DC plug to the clipper.
3. Connect the adapter to the wall socket.
4. Check the charging indicator.
5. When the indicator light of the clipper unit is red, the unit is charging.
6. When the clipper is fully charged, the indicator will change to blue.
To Next Page
Loading...