76
Initial Charge: 24 hours (first charge only)
Recharge: 2.5 hours
Cordless Operation: 90 minutes
CAUTION
• Charge at room temperature between 5°C and 35°C.
CORD OPERATION
This clipper can be operated by plugging it into the power source when the battery is
not fully charged.
1. Switch off.
2. Connect the adapter to the wall socket.
3. Connect the DC plug to the clipper.
4. Check the charging indicator. The indicator should be lit.
5. Wait for 1 minute to activate the internal parts.
6. Switch on to operate
CAUTION
• Except for the purpose of charging, always switch off and unplug the adapter
from the wall after use.
• Do not frequently use the clipper plugged without having recharged the battery,
as this may reduce the life of the battery.
BATTERY CONDITION INDICATOR
Fully charged: Blue
Less than 15 minutes use: Slow red flash
Less than 10 minutes use: Rapid red flash
MAINTENANCE
Always switch off before removing, replacing and cleaning the blade.
REMOVING AND CLEANING THE BLADE
1. A selection of blades are available from close surgical cut to 5mm hair length.
Always make sure the clipper is turned OFF before changing blades.
2. To remove blades, press the black spring lever (under blade hinge) and pull the
blade set backwards. Slide the blades off the clipper tongue.
To Next Page
Loading...