AT+CONN Connect to the specied bonded
device. It is available only when
AT+BOND=xxxxxxxxxx is executed where
“xxxxxxxxxxxx” is the 12 hex digit string
specifying remote device bluetooth
address.
AT+CONN=xxxxxxxxxxxx Connect the adapter to a specied
Bluetooth device.
“xxxxxxxxxxxx” is 12 hexadecimal digit
string specifying remote device bluetooth
address.
AT+CONNn (n=1-8) Connect the adapter to a device in the
neighborhood found through “AT+FIND?”
AT+DROP Drop the connection when the device is
in either master or slave role. It is only
allowed when the device is in connected
state
AT+ADDR
AT+ADDR? Inquire the Bluetooth address of the local
adapter.
AT+BOND For security purpose, this command is
used to specify a unique remote Bluetooth
serial adapter to be connected.
In the master role, the adapter pairs and
connects with the designated remote
slave address. In the slave mode,
this command is a lter condition to accept
the inquiry of the master device.
AT+BOND=xxxxxxxxxxxx “xxxxxxxxxxxx” is a string of 12
hexadecimal digits specifying the slave
Bluetooth Device address.
10
To Next Page
Loading...
Need help?
General
