EasyManua.ls Logo

Lochinvar CH 100 G CE - User Manual

Lochinvar CH 100 G CE
66 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
These instructions must be read and understood before installing, commissioning, operating or maintaining the equipment.
IMPORTANT INFORMATION
0310570
March 2012
Installation, Commissioning, User & Maintenance Instructions
High Efficiency Water Heaters and Boilers
Charger
Direct Gas Fired Floor Standing Water Heater
with Permanent Pilot Ignition
Models:
CH 100 G CE
CH 155 G CE
CH
and PG CE
and PG CE
200 G CE and PG CE
CH 300 G CE and PG CE
CH 400 G CE and PG CE
CH 500 G CE and PG CE
CH 600 G CE and PG CE

Table of Contents

Questions and Answers

  • R
    Robert WatsonAug 7, 2025
    Why is my Lochinvar Water Heater not igniting, but the pilot flame is lit?
    • A
      anitaclarkAug 7, 2025
      If your water heater isn't igniting but the pilot flame is lit, check that the isolator switch is turned ON and that there is power to the isolator, ensuring the measured voltage is 230 VAC (-15%, +10%).
  • D
    Diane MejiaAug 11, 2025
    What to do if I smell gas from my Lochinvar Water Heater?
    • M
      Morgan YangAug 11, 2025
      If you smell gas, immediately close the main gas valve. Do not operate any switches or use open flames. Ventilate the boiler room and contact your installation engineer or local gas company right away.
  • Z
    Zachary ScottAug 16, 2025
    What to do if my Lochinvar CH 100 G CE is leaking?
    • J
      John JonesAug 16, 2025
      If you notice a water leak, first check all threaded connections and tighten them. If the leak is coming from elsewhere, trace it to identify the source. If the water heater tank itself is leaking, consult the supplier or manufacturer. If the leakage is due to condensation, wait until the water in the heater reaches the set temperature before drawing off too much hot water.
  • J
    Joseph RushAug 21, 2025
    Why is my Lochinvar CH 100 G CE Water Heater having explosive ignitions and poor flame profile?
    • M
      Mark FinleyAug 21, 2025
      Explosive ignition and a poor flame profile can be due to incorrect supply pressure or burner pressure. Ensure that the supply pressure and burner pressure are set correctly.
  • D
    Donna AlvaradoAug 25, 2025
    What to do if my Lochinvar CH 100 G CE has no gas?
    • A
      Ashley WellsAug 25, 2025
      If there is no gas, verify that the gas valve is open. Also, check if the gas control is opening (listen for a clicking sound) and inspect the leads of the gas control.
  • P
    pwilsonAug 29, 2025
    Why is the indicator lamp red on my Lochinvar Water Heater's Power Anode?
    • M
      Mr. Alan HayesAug 29, 2025
      A red indicator lamp on the power anode suggests that the anodes are not making proper contact with the water, or that the anode is poorly earthed. Check that all connections have been made properly. Also, check all cables for breaks and replace them if necessary.
  • M
    Michelle MyersSep 2, 2025
    Why is the indicator lamp off on my Lochinvar CH 100 G CE Water Heater's Power Anode?
    • S
      Sara NunezSep 2, 2025
      If the indicator lamp is off, check the electrical supply to the potentiostat.

Lochinvar CH 100 G CE Specifications

General IconGeneral
BrandLochinvar
ModelCH 100 G CE
CategoryWater Heater
LanguageEnglish

Related product manuals