EasyManua.ls Logo

Lochinvar Shield SNR200-100 User Manual

Lochinvar Shield SNR200-100
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
TM
Installation & Service
Manual
Models: SNR150-100, SNR200-100,
SNA285-125, SNA400-125, AND
SNA500-125
This manual must only be used by a
qualified heating installer / service
technician. Read all instructions in this
manual before installing. Perform steps
in the order given. Failure to comply
could result in severe personal injury,
death, or substantial property damage.
WARNING
Save this manual for future reference.
-- Do not store or use gasoline or other flammable vapors and
liquids in the vicinity of this or any other appliance.
-- WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do not touch any electrical switch; do not use any phone in your
building.
Immediately call your gas supplier from a near by phone.
Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the fire department.
-- Installation and service must be performed by a qualified
installer, service agency, or the gas supplier.
WARNING: If the information in these instructions is not
followed exactly, a fire or explosion may result causing property
damage, personal injury or death.
SWH-I-S Rev D

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Lochinvar Shield SNR200-100 and is the answer not in the manual?

Lochinvar Shield SNR200-100 Specifications

General IconGeneral
BrandLochinvar
ModelShield SNR200-100
CategoryWater Heater
LanguageEnglish

Summary

Please read before proceeding

Hazard definitions

Definitions of DANGER, WARNING, CAUTION, and NOTICE.

WHAT TO DO IF YOU SMELL GAS

Steps to take if a gas leak is detected.

Determine water heater location

Closet and alcove installations

Criteria for closet and alcove installations.

Provide clearances

Requirements for clearances from combustible materials and service access.

Flooring and foundation

Requirements for flooring and foundation for installation.

Prevent combustion air contamination

Guidance on avoiding combustion air contamination.

Combustion and ventilation air requirements

Requirements for supplying combustion and ventilation air.

General venting

Venting and combustion air

Instructions for venting and combustion air systems.

Vent piping materials

Specifications for approved vent pipe materials and fittings.

Air contamination

Warnings about contaminants in air supply and their effects.

Sidewall direct venting

Vent/air termination – sidewall

Procedures for sidewall termination of vent and air.

Prepare wall penetrations

Steps for preparing wall openings for venting.

Sidewall termination – optional concentric vent

Details on using optional concentric vent kits for sidewall termination.

Vertical direct venting

Vent/air termination – vertical

Procedures for vertical termination of vent and air.

Vertical termination – optional concentric vent

Details on using optional concentric vent kits for vertical termination.

System piping

General piping information

Basic steps for installing water heater piping connections.

Scalding

Warnings and precautions regarding hot water temperatures and scalding.

Piping components

Recommended piping components like valves, unions, and relief valves.

Gas connections

Connecting gas supply piping

Steps for connecting the gas supply piping to the water heater.

Check inlet gas supply

Procedure for checking the inlet gas supply pressure.

Field wiring

Power cord connection

Instructions for connecting the power cord to the appliance.

Low voltage connections

How to make low voltage wiring connections to the control board.

Condensate disposal

Condensate drain

Procedure for draining condensate from the water heater.

Start-up

Check for gas leaks

Procedure for checking the system for gas leaks before startup.

Inspect/fill condensate system

Steps to inspect and fill the condensate trap and lines.

Start the water heater

Step-by-step instructions for starting the water heater.

Check flame and combustion

Procedure for checking burner flame and combustion analysis.

Operating information

Protection features

Details on safety features like temperature and rise limiting.

Water heater temperature regulation

How the control module regulates water temperature.

Sequence of operation

Step-by-step process of how the water heater operates.

Shield control module

Explanation of the control panel and its functions.

Status display screens

Description of the different display screens on the control panel.

Maintenance

Maintenance and annual startup

Schedules for annual startup and routine maintenance.

Clean condensate trap

Steps to clean and maintain the condensate trap.

Check water heater relief valve

Inspecting and testing the temperature and pressure relief valve.

Cleaning heat exchanger

Procedure for cleaning the water heater's heat exchanger.

Troubleshooting

Check control module fuses

Procedure for checking and replacing control module fuses.

Troubleshooting Chart - No Display

Steps to diagnose and resolve 'No Display' issues.

Troubleshooting Chart - Unit Does Not Modulate Above 50%

Steps to diagnose and resolve modulation issues.

Checking temperature sensors

Procedure for checking temperature sensor resistance.

Troubleshooting Chart - Noisy System

Diagnosing and resolving noisy operation issues.

Troubleshooting Chart - Flame Sequence

Diagnosing and resolving 'Flame Sequence' fault messages.

Troubleshooting Chart - No Flame Ign

Diagnosing and resolving 'No Flame Ignition' fault messages.

Combustion Analysis Procedure

Step-by-step guide for performing combustion analysis.

Gas valve adjustment procedure

Procedure for adjusting the gas valve for optimal combustion.

Diagrams

Diagrams

Electrical ladder diagram for system components.

Related product manuals