EasyManua.ls Logo

Lochinvar SMART SYSTEM 402 - 2072 User Manual

Lochinvar SMART SYSTEM 402 - 2072
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Copper-fin II/IIE
Boiler, Water Heater
and Pool Heater
Service Manual
Models: 402 - 2072
(Boiler & Water Heater)
Models: 502 - 2072
(Pool Heater)
This manual must only be used
by a qualified heating installer
/ service technician. Read all
instructions, including this
manual and the Installation
and Operation Manual, before
installing. Perform steps in the
order given. Failure to comply
could result in severe personal
injury, death, or substantial
property damage.
WARNING
Save this manual for future reference.
C(F,H,P)X-SER Rev A
Question and Answer IconNeed help?

Do you have a question about the Lochinvar SMART SYSTEM 402 - 2072 and is the answer not in the manual?

Lochinvar SMART SYSTEM 402 - 2072 Specifications

General IconGeneral
BrandLochinvar
ModelSMART SYSTEM 402 - 2072
CategoryWater Heater
LanguageEnglish

Summary

Copper-fin II/IIE Boiler, Water Heater and Pool Service Manual

Important Safety Warnings

Warning about qualified installer and reading instructions before use.

Hazard Definitions

DANGER

Indicates an imminently hazardous situation resulting in death or serious injury.

WARNING

Indicates a potentially hazardous situation resulting in death or serious injury.

Before Proceeding: Safety and Handling

Ceramic Fiber Material Handling

Safety guidelines for handling ceramic fiber materials due to potential health risks.

Maintenance and Troubleshooting Overview

Maintenance Schedules and Procedures

Schedules and tasks for annual startup, owner, and technician maintenance.

Troubleshooting Faults and Sensors

Charts for diagnosing faults and procedures for testing sensors and components.

1 Service (continued)

Parameter Table Overview

List of SMART SYSTEM control module parameters and access details.

Parameter Table Continuation

Continuation of the parameter table listing control module parameters.

2 Maintenance

Maintenance and Annual Startup Schedules

Schedules and procedures for annual startup and routine maintenance.

2 Maintenance (continued)

Relief Valve and Hot Surface Igniter Maintenance

Procedures for checking relief valve and inspecting/replacing hot surface igniter.

Heat Exchanger Inspection and Cleaning

Steps for inspecting, cleaning, and potentially removing the heat exchanger.

3 Troubleshooting

Troubleshooting Safety Warnings and Preparation

Safety warnings and checks required before starting troubleshooting procedures.

Control Module Fuse Checks

Procedure for inspecting and replacing control module fuses.

3 Troubleshooting (continued)

Noisy System and Pump Operation Faults

Charts for diagnosing noisy systems and non-operating pumps.

Operator Interface Fault Message Guide

Guide to interpreting and correcting fault messages on the operator interface.

Ignition, Flame Signal, and Circuit Faults

Corrective actions for ignition failures, loss of flame signal, and circuit errors.

Loss of Flame Signal and High Limit Faults

Corrective actions for losing flame signal and exceeding auto reset high limit.

Related product manuals