12
3: Once self-check completes ensure the
lock operates smoothly by manually
locking and unlocking the door using the
deadbolt should operate smoothly
without any interference or binding. If
necessary, repeat step 2 and ensure
that (a) the deadbolt was extended
and (b) the torque blade was inserted
vertically while the deadbolt was extended.
4: Once self-check is complete, install the
battery cover H and secure with screw on
top (do not over tighten).
1: With door open and deadbolt fully extended,
place ribbon inside compartment and insert 4
batteries (note correct -/+ polarity).
2: After all batteries are installed, PRESS and HOLD
the program button for 10S. The lock will automati-
cally start self-check (release program
button once
check starts). The self-check process
determines
right or left swinging door
and is very important
to ensure correct installation.
IMPORTANT: if lock
is not properly installed it will open and close repea-
tedly.
INSTALLING BATTERIES
PRESS
& HOLD
Step 5
1
2
3
4
To Next Page
Loading...
Need help?
General
