Lockly DEADBOLT SECURE PLUS User Manual

4.7 Safe Mode - Overview
SECTION 4.7
Lockly will enter Safe Mode when three (3) consecutive wrong Access Codes are entered within
5 minutes. When in Safe Mode, the lock status icon will start to flash.
To disable Safe Mode, you must unlock the door using the correct fingerprint or enter the correct
Access Code twice in a row. Activate the keypad by pressing and holding for 3 seconds.
Once the screen is activated, enter the correct Access Code carefully twice, pressing after
every time.
If you enter the wrong code, the keypad will then be disabled for 10 minutes.
Countdown Prompt
(Displayed in Minutes)
Will start with 10 and
countdown until 0.
You will see a “10” on the screen, notifying the number of minutes that the keypad is disabled for.
After 10 minutes, you may attempt to enter the correct Access Code to unlock the door. After the
second incorrect attempt to unlock the lock with the wrong Access Code, Lockly will disable the
keypad for 20 minutes, displaying a “20” on the screen. After the third wrong attempt to unlock the
door with the correct Access Code, the screen will be disabled for 30 minutes. (Example A and
Example B above).
Note: In order to conserve power, the countdown prompt will only be displayed for 3 seconds. You
can reactivate the screen by sliding your hand across the screen.
Example A Example B
23

Lockly DEADBOLT SECURE PLUS Specifications

General

Brand	Lockly
Model	DEADBOLT SECURE PLUS
Category	Door locks
Language	English