8
Lockly Secure Pro comes with a pre-wired door sensors consisting of two parts:
Part (P) - Wired Sensor
Part (Q) - Sensor Magnet
About door sensors
Door sensors provide real-time door condition status, such as the ability to verify if the
door is securely closed. It also sends push notifications to your phone whenever your
door opens and enables voice control with Amazon Alexa or Google assistant.
Removal of Sensor (optional)
There may be circumstances where the sensor cannot be installed because of molding/
door limitations or is not aesthetically desirable. The sensor wired to the lock is removable
by carefully pulling its connector from the circuit board. If removed, some features and
functionality will not be available, such as real-time condition status.
IMPORTANT: Gap must be less than 3/4” when installed.
When installed on door, the distance between the wired sensor and
sensor magnet must be less than 3/4” in order for the sensor to work.
If door frame is higher than door, add included foam pads to level
parts (P) and (Q) with each other as much as possible.
PREPARING DOOR SENSORS FOR INSTALLATION
Step 4
Do not mount (install) door sensors yet. You will install in step 7.
TIP:
Lockly door sensors comes in Grey (PGA715) and Matte Black (PGA716) that
can be ordered through our customer hotline: (669) 500-8835 or by email:
help@Lockly.com.
To Next Page
Loading...
Need help?
General
