LockState LS-RDJ - User Manual

The LS-RDJ comes standard with the
following features:
• 1 unique master code
• 9 unique user codes
• Low Battery Alarm
• External power capability
• Manual override keys
• Tamper-proof error function
• Easy installation
1. INSTALLATION
1.1 Lock Diagram
Below is a diagram of the LS-RDJ with
numbers indicating areas of function. These
numbers correspond with their description in
the box below:
1.2 Door Diagram
If you are installing the LS-RDJ in a
door with pre-drilled holes, the lock
will fit most standard doors. To
confirm that the lock will fit your door,
please verify the following
measurements:
1. Backset is either 2 3/4” or 2 3/8”
(backset is the measure from the edge of
the door to the center of the knob hole)
2. Door knob hole is 2 1/8”
3. Latch Hole is 7/8”
(see figure below)
1.3 Installing the Batteries
The battery case is located in the lower
half of the outside lock piece.
Remove the battery case by inserting
the small green screw driver through
the bottom hole of the back side of
the front mount (see below). As you
press the screw driver through the
hole the case will release from the
bottom of the mount. Place 4 AA
batteries in the case and replace the
case in the mount.
Fig. 1
1
Handle (Left handle or Right handle)
2
"S" key (setup key) for setting new codes
3
Green light indicating the lock is open
4
Socket for external power (6V)
5
Red light indicating the lock is not open
6
Digital keypad (digits 0-9)
7
"ON" key used for unlocking the lock
8
Emergency manual keys

Summary

Installation

Lock Diagram

Diagram showing lock components and their functions, identified by numbers and descriptions.

Door Diagram

Diagram detailing door measurements required for lock installation, including backset and hole sizes.

Installing the Batteries

Instructions on locating, removing, and replacing the battery case for the lock.

Installing the Lock

Steps for installing the latch, front mount, and back mount of the lock onto the door.

Programming

Setting & Changing the Master Code

Steps to set or modify the master code, including initial factory code and digit requirements.

Setting & Changing the User Codes

Guide on creating new user codes and modifying existing ones using master or current user codes.

Canceling and Resetting Codes

Procedure to cancel all user codes or reset the master code if forgotten.

Opening the Lock

Opening the lock with a User Code or a Master Code

Procedure for unlocking the door using a valid master or user code entered on the keypad.

Opening the lock with an Override Key

Instructions for accessing and using the manual override key to open the lock.

Keeping the Lock Powered

Battery Warning System

Alerts for low battery power and continued functionality duration after warning.

External Power Option

Method for powering the lock externally using a 6V output source when batteries are depleted.

LockState LS-RDJ Specifications

General

Compatibility	iOS, Android
Keypad	Yes
Lock Type	Deadbolt
Auto-Lock	Yes
Remote Access	Yes
Key Override	Yes
Battery Life	Up to 1 year
Connectivity	Bluetooth
Power Source	Battery
Voice Control	Yes