Need help?Do you have a question about the LockState RemoteLock LS-5i and is the answer not in the manual?
Adjusts the latch to fit 2-3/8" (60mm) or 2-3/4" (70mm) backsets for deadbolt and lever locks.
Determines if the door is left-handed or right-handed based on hinge location.
Inserts the latch into the door and secures it with screws.
Inserts the strike plate into the door frame and secures it with screws.
Installs the keypad assembly for deadbolt or lever locks, ensuring correct tailpiece orientation.
Mounts the interior plate using screws, adjusting for alignment if necessary.
Connects the receiver module to the door using screws, with optional wood screws.
Sets the door handing for deadbolt locks, crucial for initial operation.
Inserts 4 AA Alkaline or Lithium batteries into the receiver module.
Details how to remove and exchange interior and exterior levers for proper handing.
Used for entering codes, setting functions, and as a lock button.
Input buttons for codes and function programming.
Allows locking/unlocking the lockset from the exterior.
Prevents water permeation into the lockset.
Slides to allow changing the batteries.
Holds four AA (1.5v) Alkaline or Lithium batteries.
Restores default settings.
Allows locking/unlocking the lockset from the interior.
Requires 6v, four AA (1.5V) batteries; low battery warnings at 4.25V and 3.75V.
Preset code is 123456; length 4-10 digits.
Programmed via PC, max 10 codes, length 4-10 digits. Default is 1234.
Programmed via web portal, can follow access schedules, length 4-10 digits.
Automatically relocks after unlock delay (default 5s), enabled on lever models.
Lock remains unlocked after code entry, enabled on deadbolt models.
Beep codes for operations, programming, errors, and low battery warnings.
Flash codes for operations, programming, errors, and low battery warnings.
Reset settings by holding 'R' button within 10s of power cycling.
Instructions for setting locked/unlocked positions for deadbolts.
Unlocked by key, code + LockState, or interior turn knob.
Locked by key, LockState button twice, or interior turn knob.
Critical step for deadbolt operation; requires unlocked position.
Procedure to lock the door using the keypad.
Procedure to unlock the door using a PIN.
Updates the primary programming code for security.
Adds a new local code for user access, up to 10 codes.
Removes a specific local code from the system.
Clears all local codes, restoring default code 1234.
Resets the lock's Wi-Fi configuration to factory defaults.
Activates automatic relocking after unlocking.
Configures the delay time for the auto-lock feature (5-20 seconds).
Disables automatic relocking, enabling passage mode.
Disables audio feedback from the keypad.
Re-enables audio feedback from the keypad.
Enables Wi-Fi wake-up function if key press setting is off.
Adds a remote control device, up to 5 remotes.
Removes all paired remote control devices.
Refer to pages 1-4 for detailed installation steps.
Follow instructions on page 4, step 7 for deadbolt door handing setup.
Refer to separate guide for connecting lock to Wi-Fi network.
Instructions on how to unlock and lock the door.
To Next Page
General
