13.1 - Emissions test
The Lode equipment is intended for use in the electromagnetic environment specified below. It is the
responsibility of the customer or user to ensure that the Lode equipment is used in such an
environment.
Emissions test:Emissions test: RF emissions CISPR11
Compliance:Compliance: Group 1
Electromagnetic Environment – GuidanceElectromagnetic Environment – Guidance:The equipment uses RF energy only for its internal function.
Therefore, its RF emissions are very low and are not likely to cause any interference in nearby
electronic equipment.
Emissions test:Emissions test: RF emissions CISPR11
Compliance:Compliance: Class B
Electromagnetic Environment – GuidanceElectromagnetic Environment – Guidance:The equipment is suitable for use in all establishments
including domestic establishments and those directly connected to the public low-voltage power
supply network that supplies buildings used for domestic purposes.
Emissions test:Emissions test: Voltage fluctuations / Flicker emissionsIEC 61000-3-3
Compliance:Compliance: Complies
Electromagnetic Environment – GuidanceElectromagnetic Environment – Guidance:The equipment is suitable for use in all establishments
including domestic establishments and those directly connected to the public low-voltage power
supply network that supplies buildings used for domestic purposes.
Emissions test:Emissions test: Harmonic Emissions IEC 61000-3-2
Compliance:Compliance: Not applicable
Electromagnetic Environment – GuidanceElectromagnetic Environment – Guidance:Equipment for professional use with a total rated power
greater than 1 kW and is excluded from this requirement
To Next Page
Loading...
