Programming
User Command Functions
Programming and Installers Guide
Door Station Communications
*#1
*#72
*#73
*#77
*4
*4
*5
To Connect and communicate to the Door Station Speaker
To Enable Call Forwarding
To Disable Call Forwarding
To Toggle Ringer ON/OFF
To Connect to Door Station Speaker while putting your existing
telephone caller on hold
To switch from the Door Station Speaker back to your existing
telephone caller
Activates Relay for 10 seconds
Call Forwarding
Door Station ON-HOLD
Relay Activation
(Listen for -Beep )
(Listen for -Beep )
(Listen for -Beep )
(Listen for -Beep )
2s
3s
#1 2 s
Activates Relay#2 for 6 seconds 2 s
(2-Beeps=ON, 3-Beeps=OFF)
(Speaker button must be pressed and a call
waiting tone must be heard before the command can be used)
*4
(Speaker button must be pressed and a call waiting tone
must be heard before the command can be used)
*4
*8
PRESS to go into programming mode*#0 (Listen for 2 beeps)
NOTE: All Programmed Phone
Numbers for each Dwelling Unit will be
deleted. Use only for mandatory reset
purposes only. NOT FOREND USERS
PRESS
To RESET UNIT TO
FACTORY DEFAULT
0#0
PRESS
(To Program Call Forwarding No.)
*2 (Listen for 1-Beep)
1) Enter the Phone Number you wish to Call
Forward to.
2) PRESS to SAVE
(up to 30 Digits)
130
*
#
to Digits
Note: ENTER for inserting a PAUSE (6 Second
Delay) anywhere in the dialing sequence.
(Listen for 2-Beeps)
To DELETE an existing programmed phone number you
ENTER only for Step #1 followed by to SAVE.
*#
Page 7
ENTER passcode 1111 (Default Passcode)
NOTE: When Entering any programming functions, you have up to 30 seconds idle time before the system
will hang up at which point any programming started will not be saved
Then listen for Beeps
To Next Page
Loading...
