EasyManuals Logo

Logik L10SPDV13 User Manual

Logik L10SPDV13
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
18
Charging the Battery
1. Connect the mains adapter (included) to the DC IN socket at the right side of the unit
and then connect the mains adapter to a mains socket.
The LED indicator illuminates green indicating that the battery is in charging mode.
When the battery is charged to full capacity, the LED indicator will light up green.
2. Remove the mains adapter. The battery is now fully charged and the unit is ready to
use.
Using the Car Power Adapter (for in-car use)
The 12V car power adapter (included) allows the unit to be used with vehicles that have a
12V negative ground electrical system.
• Before plugging in this car adapter, please check the output rating of your car
cigarette lighter rst.
• Disconnect the car power adapter when not in use. Not for use in 24V vehicles.
• Use the provided 12V car power adapter only. Using other car power adapters
could damage the unit.
• In the interest of trac safety, do not operate this unit or view videos while
driving.
• Make sure the unit is securely fastened to prevent it from falling or ying
through the air in the event of an accident.
• When the inside of the cigarette lighter socket is dirty with ash or dust, the plug
section may become hot due to poor contact. Be sure to clean the cigarette
lighter socket before use.
• After use, disconnect the 12V car power adapter from both the unit and the
cigarette lighter socket.
SD / MMC AV OUT COAXIAL
DC IN 9-12V
ON OFF
SD / MMC AV OUT COAXIAL
DC IN 9-12V
ON OFF
DVD Player Right Side
DVD Player Right Side
To DC IN 9V-12V Socket
To DC IN
9V-12V Socket
To the Mains
Socket
To Cigarette
Lighter Socket
* Battery Operation time from fully
charged battery = Approx. 2 hours
• The battery is partially charged at shipment. We suggest that for rst time use
fully charge the battery. It may take up to 4 hours to fully charge the battery.
• Every time you see the Low Battery indicator on the screen, you must connect
your mains adapter to the unit and the mains socket. The battery will now start
to recharge.
• The battery will charge slower when the DVD player is in use.
• It is recommended to turn o the unit while the battery is charging.
L10SPDV13_IB_161013_will.indd 18 13/10/2016 10:09 AM

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Logik L10SPDV13 and is the answer not in the manual?

Logik L10SPDV13 Specifications

General IconGeneral
BrandLogik
ModelL10SPDV13
CategoryPortable DVD Player
LanguageEnglish

Related product manuals