TURNING THE UNIT ON
When the AC power cord is connected, the standby indicator lights on. Press the / I button to turn
the unit on, the standby indicator will blink for about 10 seconds for loading, and will finally light off until
the above screens shown. Press the FUNCTION button to select the desired mode (DTV, TV, AV1,
AV2/SCART, YUV/SCART, DVD or HDMI). If you select DVD mode, the DVD logo will appear on the
screen.
Note:
When the unit is not going to be used for a long time, disconnect the AC power supply cord from AC
outlet.
TURNING THE UNIT ON FOR THE FIRST TIME
The first time you turn the unit on, it will go straight into Auto scan mode. Simply follow the screen
prompts as below to tune in the channels.
1. Use the / button to select the screen menu language you prefer.
2. Use the button to move to Auto Tuning, press the ENTER/OK button to enter Auto Tuning
menu.
3. Use the / button to select the Country you are in.
4. Use the button to move to Start. Press the ENTER/OK button confirm Start. The system will
automatically start to scan and preset all available programmes.
5. After scanning has finished, the TV will display the first programmes stored of DTV programme.
BASIC OPERATION
PREPARATION
CONNECTIONS USING THE FEATURES SPECIFICATIONTROUBLESHOOTING
USING THE DVD
FEATURES
To Next Page
Loading...
Need help?
General
