Starting a Wash Cycle
1. Ensure the unit is connected to the mains power and the water supply is fully opened (water pressure
between 0.04MPa and 1.00MPa).
2. Open the door. Pull out the dishwasher baskets, load the dishes and push the baskets back.
3. Pour in the detergent or place the detergent tablet in the detergent compartment and close rmly afterwards.
4. Close the dishwasher door. A click sound should be heard when the door is closed correctly. Do not slam the
door.
5. Press the On/O button, the power indicator light will illuminate.
6. Select the wash cycle programme based on the loading and soil requirements. Please refer to the section
Wash Cycle Table.
7. The indicator light of the selected programme will illuminate.
8. Press the Start/Pause button, the washing cycle will begin shortly.
Changing a Programme
To change the programme if the washing cycle has already started, follow the steps below.
1. Open the door slightly to avoid water spillage before opening the door fully. Check if the unit has dispensed
the detergent or detergent tablet. This will depend on how long the washing cycle was running for.
2. If the detergent dispenser lid is opened, we suggest you to allow the wash cycle to complete.
3. If the detergent dispenser lid is still closed, press the On/O button to cancel the programme. You may then
close the dishwasher door and press the On/O button again. Then, turn the dial to select the required
programme and conrm the selection by pressing the Start/Pause button. The unit will start the new
washing cycle shortly.
At the End of a Programme
At the end of the programme, the dishwasher will beep.
If you open the dishwasher’s door during the washing cycle and then close it, the dishwasher will
continue the current washing programme after 10 seconds. However, if the door is not closed correctly
after 1 minute, the dishwasher will beep at 1 minute intervals.
To Next Page
Loading...
Need help?
General
