EasyManua.ls Logo

Logik LDWTT20N - Starting a Wash Cycle; Changing a Programme; At the End of a Programme; Switching off the Unit

Logik LDWTT20N
144 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
24
GB
Starting a Wash Cycle
1. Ensure the unit is connected to the mains power and the water supply is fully opened (water pressure between
0.04MPa and 1.00MPa).
2. Open the door. Pull out the dishwasher baskets, load the dishes and push the baskets back.
3. Pour in the detergent or place the detergent tablet in the detergent compartment and close rmly afterwards.
4. Close the dishwasher door. A click sound should be heard when the door is closed correctly. Do not slam the
door.
5. Press the Power button.
6. Select the wash cycle programme based on the loading and soil requirements. Please refer to the section Wash
Cycle Table.
7. The indicator light of the selected programme will illuminate.
8. Press the Start/Reset button, the washing cycle will begin shortly. The programme indicator will blink normally
per second during operation.
Changing a Programme
To change the programme if the washing cycle has already started, follow the steps below.
1. Open the door slightly to avoid water spillage before opening the door fully. Check if the unit has dispensed
the detergent or detergent tablet. This will depend on how long the washing cycle was running for.
2. If the detergent dispenser lid is opened, we suggest you to allow the wash cycle to complete.
3. If the detergent dispenser lid is still closed, close the dishwasher door, press the Start/Reset button to pause
the washing. Then press and hold Start/Reset until the unit becomes standby state. Press Program again to
select the new programme and conrm the selection by pressing the Start/Reset button. The unit will start
the new washing cycle shortly.
At the End of a Programme
At the end of the programme, the dishwasher will beep.
Switching O the Unit
To save energy, remember to switch the dishwasher o using the Power button. The dishwasher will continue to
use electricity unless it is switched o with the Power button.
If you open the dishwasher’s door during the washing cycle and then close it, the dishwasher will
continue the current washing programme after 10 seconds.
If the dishwasher is not going to be used for a long period of time, e.g. whilst on holiday, disconnect the
unit from the mains supply.
A forgotten dish can be added if the detergent dispenser is still closed. Pause the dishwasher, carefully
open the door and add the dish. Close the door and restart the machine. Be very careful of the hot
steam and water while the door is open.
Save energy
Manual pre-rinsing of items leads to increased water and energy consumption and is not
recommended.
Washing tableware in a household dishwasher usually consumes less energy and water than
hand dishwashing provided the household dishwasher is used according to the manufacturer’s
instructions.
LDWTT20N_IB_5L_RC_Final221111.indb 24LDWTT20N_IB_5L_RC_Final221111.indb 24 11/11/2022 3:43 PM11/11/2022 3:43 PM

Table of Contents

Related product manuals