Levelling the Unit
To do this adjust the two levelling feet at the front of the
unit.
If the unit is not level, the doors and magnetic seal
alignments will not be covered properly.
Cleaning Before Use
Wipe the inside of the unit with a weak solution of bicarbonate of soda. Then rinse with
warm water using a damp sponge or cloth. Wipe completely dry before replacing the shelves
and drawers. Clean the exterior of the unit with a damp cloth.
If you require more information refer to the Cleaning section.
Before Using Your Unit
Before placing any food in your unit, turn it on and wait for 24 hours, to make sure it is
working properly and to allow it time to fall to the correct temperature. Your unit should not
be overfilled.
• Before Plugging in YOU MUST
Check that you have a socket which is compatible with the plug supplied with
the unit.
• Before Turning On!
Do not turn on until two hours after moving the unit. The coolant fluid needs
time to settle. You may damage the cooling circuit if the unit is turned on too
soon.
17. Remove the plastic washer. Turn the
middle hinge 180º, replace the washer
on the upper pin. Assemble the freezer
door and fridge door together with the
middle hinge (Reverse operation of item
2) Fix the middle hinge by tightening the
screws.
18. Finally, by using a craft knife cut the left
side of the kick plate where marked and
reassemble onto the fixing clips.
To Next Page
Loading...
Need help?
General
