Logik LHP8W22 User Manual

21
Cleaning the Heat exchanger
• Allow the heat exchanger to cool down before cleaning.
• Do not touch the heat exchanger ns.
1. Turn o the dryer and remove the plug from the mains. Allow the dryer to cool down.
2. Open the heat exchanger ap on the front of the dryer.
3. Release the blue clips and remove the cover.
4. Remove any dust or u from the heat exchanger by vacuuming the ns, clean between all
the metal ns. Be careful not to touch the ns as you may damage them.
5. Replace the cover and close the blue clips.
6. Close the heat exchanger ap on the front of the dryer.
Cleaning the Humidity Sensor
If you look inside the drum you will see 2 metal strips. They are at the front of the drum behind
the lint lter. These need cleaning from time to time at least 4 times a year.
• Allow the dryer to cool down. Open the door, you might want to remove the lint lter so you
can access the sensor easier.
• Wipe the sensor with a damp cloth, remove any lint or u is there is any stuck to the sensor.
Do, not use any cleaning products when cleaning the sensor.
Logik 8 kgs Heat Pump Tumble Dryer LHP8W22 Manual.indd 21Logik 8 kgs Heat Pump Tumble Dryer LHP8W22 Manual.indd 21 26/09/2022 15:1726/09/2022 15:17

Logik LHP8W22 Specifications

General

Brand	Logik
Model	LHP8W22
Category	Dryer
Language	English