Logik LID45W20 - Maintenance; Frost Precaution; Moving the Dishwasher

31
• Avoid over tilting the unit during transportation.
• We recommend that 2 people handle the dishwasher during installation.
Do not attempt to remove the spray arms.
Spray arms
Particles of food can get stuck in the spray arm jets
and bearings. The spray arms should therefore be
checked and cleaned regularly.
• Ensure the dishwasher is switched o. Use a
pointed object, e.g. a cocktail stick, to loosen food
particles in the spray arms’ jets.
Frost Precaution
Avoid placing the dishwasher in a location where the temperature is below 0°C. If your appliance
is left in an unheated place over the winter, you are advised to:
1. Disconnect the unit from the water inlet.
2. Turn on the unit. Select any wash cycle and let it run for 1 minute only. This will allow all the
excessive water that remains in the unit to drain out.
3. Disconnect from the mains socket.
4. Empty the dishwasher.
5. Close the dishwasher’s door.
6. Disconnect the unit from the water drain. Use a suitable receptacle to catch the water.
Should you encounter any diculties with the above steps, please ask a service technician for
assistance.
Moving the Dishwasher
If you have to move the unit, for instance due to moving house, you are advised to:
1. Disconnect the dishwasher from the mains socket.
2. Disconnect the unit from the water inlet and drain. Use a suitable receptacle to catch the
water.
3. Remove the unit from the current location with the hoses discharged.
4. Pull the unit out together with the hoses.
LID45W20_IB_Final200727.indd 31LID45W20_IB_Final200727.indd 31 27/7/2020 4:23 PM27/7/2020 4:23 PM