2. Remove the four blanking plates
from the top of the freezer with a flat
bladed screwdriver. Remove the screws
underneath with a Phillips screwdriver.
3. Use the 8mm socket or spanner to
remove the three bolts above the door
hinge. Lift off the bracket. Remove the
freezer door.
4. Remove the pin from the bracket and
replace it into the same hole from the
other side.
5. Remove the hinge insert plate from the
bottom of the freezer door. Replace the
plate on the opposite side.
6. Tilt the freezer back, no more than 45°,
to access the bottom hinge and feet.
Remove the feet and the bolts securing
the right hand hinge plate and left hand
fixing plate.
7. Remove the pin and reattach it to where
the hinge bracket was located on the
opposite side (right to left). Place the
hinge on the opposite side of the cabinet,
secure it with three bolts, screw the foot
into position.
* All images are for reference only; please refer to your individual unit for actual item.
To Next Page
Loading...
