Private and Confidential, Internal Use Only, Not for External Distribution 07/26/11 |27 of 27
There are two methods for placing the Harmony Link in safe mode.
Method 1
1. Disconnect the power from the Harmony Link.
2. Press and hold down the red reset button located on the bottom of the Harmony Link. While holding
the red button, plug the Harmony Link back in to a power source.
3. Do not let go of the red button until the LED status light is blinking red.
Method 2
Regardless of the LED status light color, and with the Harmony Link plugged in to a power source, press
and hold the red reset button located on the bottom of the Harmony Link until the LED status light color is
blinking red.
To Previous Page
Loading...
Need help?
General
