Logitech MouseMan - Connecting the Mouse

Connecting the Mouse
The mouse connects to either a PS/2 mouse port or a 9-pin serial port.
1. For a PS/2 mouse port installation only, turn off the computer.
2. Connect the mouse cable into the 9-pin serial port on the computer.
For PS/2 mouse port installation, remove the 9-pin adaptor before connecting
the mouse cable to the computer.
PS/2 mouse port 9-pin serial port
3. Turn on the computer, then install the Logitech® MouseWare® software.
Installing the MouseWare’ Software
The Logitech MouseWare software must be installed to use all the features of your
Logitech mouse.
Under Windows 95
1. Start Windows 95 and insert software diskette #1 into drive A or B.
2. Click Start on the Taskbar and select Run.
3. From the Run dialog box, select (or type) A:\SETUP or B:\SETUP and
click OK. Follow the on-screen instructions.
Under Windows 3.1
1. Start Windows and insert software diskette #1 into drive A or B.
2. Open the File menu and choose the Run command. Windows displays the Run
dialog box.
3. In the Command Line text box, type: A:\SETUP (or B:\SETUP) and click OK.
The Installation dialog box is displayed. Follow the on-screen instructions.