Logitech PRO RACING PEDALS

11 ENGLISH
NOTE:
We do not recommend using combinations that include
thesoftbeige piece if the PRO Pedals are hard mounted
intoasimulation rig / seat as this will likely result in damage
tothe elastomer.
Conversely, we do not recommend using the hard elastomers
if you are using the pedals in a desk-based scenario. Unless the
pedals are secured in some manner this could easily result in
thepedals tipping when applying the brake, or the pedals sliding
away from you.
Once you have chosen your elastomer pieces apply a small
amount of the included grease to the sides of the pieces and
insert them back into the piston body remembering to insert
thesmall piece rst. Two or three drops applied to various sides
of the elastomer and spread using the tip of the bottle should be
more than enough.
Once the elastomer pieces are back in the piston body you can
reattach it to the cap on the brake pedal module and then
reinsert it into place using the same method as the other pedals.
SAFETY WARNING:
With the very hard pieces of elastomer (and especially if using
the small hard foam dampener) some strength will be required
to squeeze the piston body enough to enable it to be reinserted
into place. Please do take care to avoid trapping yourngers
between the piston body and the pedal module casing.
Oursuggested method for doing this as depicted in this manual
should help avoid this possibility.
!