Replacement faders are available complete with ribbon cables and connectors for
quick repairs. You may choose Selmark or optional Penney & Giles replacement
faders. See the Appendix for a list of Logitek part numbers for use in ordering
replacements.
Each fader has illuminated OFF and ON push buttons at the lower end of the
fader. The mix bus selector buttons and the input selector and display are at the
top of the fader.
ON/OFF Buttons are momentary and illuminated with LEDs. External device
controls such as start and stop or auxiliary actions such as muting or mix-minus
can be attached to the functions of the source ON buttons when configuring the
Audio Engine. The external controls require momentary closures. These attached
functions will follow any change of inputs.
Replacement buttons, lens caps and LEDs are available from Logitek. Part
numbers are listed in the Appendix.
Mixer Pots are designed to feel to the operator like a traditional slider. External
control or auxiliary actions can be programmed to occur at a point in the slider
travel when configuring the Audio Engine.
Bus Assign buttons are momentary action and have indicator
LEDs. The action of the PGM and AUX1 buttons is independent
so either or both can be assigned at once. Operation is Push ON /
Push OFF.
Cue is controlled by the momentary push button with indicator
LED. Cue can also be set to turn on with a fader “click-down”.
This is set during configuration. The action of the cue output can
be independent of the fader pot or configured to turn off when the
pot is brought up. When set as independent, the action of the
button is Push ON / Push OFF. For remote operation through
GPI control, the external closure must be sustained for the fader
to remain in Cue.
10
ROC-10/ROC-5 Control Surface
To Next Page
Loading...
