EasyManua.ls Logo

logitrans EHL 1004 User Manual

logitrans EHL 1004
10 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
EHL 1004EHL 1004
EHL 1004EHL 1004
EHL 1004
Instruction ManualInstruction Manual
Instruction ManualInstruction Manual
Instruction Manual
Maintenance
Question and Answer IconNeed help?

Do you have a question about the logitrans EHL 1004 and is the answer not in the manual?

logitrans EHL 1004 Specifications

General IconGeneral
Rated capacity1000 kg
Load Capacity1000 kg
Fork length1150 mm
Power TypeElectric
Battery Voltage24 V

Summary

2.0 Electrical Supply and Battery Management

2.1 Battery Specifications

Detailed specifications for three battery types for EHL 1004, including voltage, capacity, and life cycles.

2.2 Battery Checking Methods

Explains two methods for checking battery charge: acid density and voltage measurement.

2.3 Battery Charging Procedure

Outlines the correct procedure for charging batteries, including charger settings and temperature limits.

2.4 Battery Safety Warnings

Advises on safety precautions during battery handling and charging, noting explosive gases and temperature effects.

2.5 Battery Charge Indicator

Explains the function and interpretation of the battery charge indicator lights (Red, Yellow, Green).

2.6 Fuse System

Details the 80A, 30A, and 5A fuses for motor protection and electrical overload in the circuit.

3.0 Long-Term Highlifter Care

3.1 Lubrication and Oil Change Guidelines

States no lubrication is normally required; specifies ISO VG 32 hydraulic oil with concentrate.

3.2 Hydraulic Oil Change Procedure

Step-by-step guide to changing the hydraulic oil, including tank removal, cleaning, and refilling.

3.3 Cold and Humid Operating Conditions

Explains how cold affects oil viscosity and warns about condensation in hydraulic systems.

3.4 Bleeding the Hydraulic System

Describes the process of bleeding the hydraulic system by raising and lowering the forks with a load.

3.6 Cleaning

Provides instructions on cleaning the highlifter, advising against directing jets onto bearings and seals.

4.0 Fault Location and Troubleshooting

4.0 Fault Location Key

Introduces a key to identify common symptoms and their potential causes for troubleshooting.

Troubleshooting Chart

A chart correlating specific faults (A-F) with possible causes and corresponding solution points.

Related product manuals