11
OEV
ö
µ
PP
PP
OEV
NJ
NJ
µ
Replacement:
Before replacing fuse, disconnect battery + pole. The old fuse can then be removed
and replaced by a new one of the same size.
Do not insert a larger fuse; the fuse acts as a protector for the pump motor.
Find out why fuses blow!
B: Safety/pressure relief valve: protection against mechanical
and hydraulic overload.
Factory-set for maximum design load
Emergency stop
The highlifter has an emergency stop. When activating
the emergency stop, the main current supply is switched
off. The movement of the forks stops immediately when
activating the emergency stop.
2.7 Wiring connections
Much operational disturbance is caused by poor connections in the electrical
circuit. Make sure connections are in order.
Check connections regularly for damage at insulating caps or looseness at plugs,
etc.
Verdigris must be removed from lead plugs. Keep all screw/nut connections tight.
To Next Page
Loading...
