LogTag TRIX-8 V2 - Appendix 4: Firmware Programming Specification

LogTag TRIX-8 V2 Work Instruction Manual Revision 10.17 Page 42/44
APPENDIX 4 : Firmware Programming Specification
Firmware : LogTag TRIX-TREX Recorder Firmware v1.49
Filename : TRIX_PIC16LF1704_v149.HEX (Intel Hex format)
Dated : 19/07/20 08:14 PM
Processor : Microchip PIC16LF1704-I/SO
Programming Specification:
Configuration Bits:
FOSC
INTOSC
I/O function on CLKIN pin
WDTE
Watchdog Timer
OFF
PWRTE
Power Up Timer
OFF
MCLRE MCLR
Pin Function
MCLR pin function select
CP
Flash program memory code protection
ON
BOREN
Brown Out Reset
OFF
CLKOUTEN
Clock out enable
OFF
IESO
Internal-External Switch over
OFF
FCMEM
Fail Clock Monitor Enable
OFF
WRT
Flash Memory Self Write Protection
OFF
PPS1WAY
Peripheral Pin Select one-way control
OFF
ZCDDIS
Zero-Cross detect disable
ON
PLLEN
PLL Enable
OFF
STVREN
Stack Overflow / under flow reset enable
ON
BORV
Brown Out Reset Voltage Selection
LO
LPBOR
Low power Brown out reset
OFF
LVP
Low voltage programming enable
Disabled
MPLABX checksum: 0xA79D (without Code Protect ON)
0x26A6 (with Code Protect OFF)
Programming Specification:
Configuration Bits: Oscillator : LP
Watchdog Timer : Disabled
Code Protect : ON
Programming voltage : 9.0V
VDD nom : 3V
Verify VDD high : 3.6V
Verify VDD Low : 2.5V
Must be programmed with the Microchip PM3 production programmer using LT_PM3-ICP TRIX
software version 2.7 Build 92 (distributed in production software installer "LT_PM3-
setup_27r92.exe" or later. See PM3 ICP WIM.