LogTag TRIX-8 V2 - Appendix 5: ICP Locations

LogTag TRIX-8 V2 Work Instruction Manual Revision 10.17 Page 43/44
APPENDIX 5 : ICP locations – 011220 PCBA
The 011220 PCB support in-circuit programming (ICP) of the PIC16LF1704 processor.
Below details the connections for ICP.
Name
ICSP-PROG
PIC16LF17 pin#
Location(x,y) mm
Description
VDD
VDD (RED)
1
17.2, 34.3
+3V connection
GND
GND (BLK)
14
35.0, 34.3
GND connection
VPP/MCLR
MCLR (YLW)
4
20.2, 28.9
Programming voltage/Master Reset
ICSPDAT
DAT (ORG)
13
23.8, 17.0
Serial programming data
ICSPCLK
CLK (VLT)
12
21.2, 17.0
Serial programming clock
Note :
These locations are intentionally the same as the HAXO-8 2.2 ICP fixture ICP locations allowing this PCBA
to be also used in the HAXO-8 ICP fixture.
.
(0,0)
ORIGIN
ICSPDAT
ICSPCLK
VPP/MCLR
GND
VDD
NOTE:
LINK MUST BE OPEN
FOR IN-CIRCUIT
PROGRAMMING
Ø1.7mm
(41.1, 36.8)
Ø4.0mm
(5.6, 14.5)
Ø1.7mm
(2.0, 32.8)
Ø4.0mm
(36.7, 2.9)
(42,8,42.2)